使用Nutanixce启动服务器可启动Pendrive
成功安装了Nutanixce
能够ping主机IP,即192.168.1.20
无法ping cvm ip,即192.168.1.21
最好的答案灰烬
\nBelow are the steps information is reuired to who are using or installing NutanixCE 1st time....\n
\nInfra reuired:-
\nIts my LAB
\n3nodes:
\nBelow Configuration is per node
\n2SSDs 250GB raid1
\n3HDDs 300GB
\n128GB RAM
\n1 pendrive
\n
\n(You can proceed with below minimum infra
\n3nodes:
\nBelow Configuration is per node
\n1SSDs 250GB
\n1HDDs 300GB
\n24GB RAM (plz verify)
\n1 pendrive)
\n
\n
\nSteps:-
\n
- \n
- Download NutanixCE image<\/b> \n
- Unzip the image, it will unzip from .gz to .img<\/b> \n
- Download and install Win32 Disk Imager for create bootable Pen drive using the .img image<\/b> \n
- Connect the bootable pen drive to one of the physical server and boot it from pen drive.<\/b> \n
- Nutanix Installation windows will open<\/b> \n
- Enter<\/b> \n
- Type install<\/b> \n
- Select by default US and Proceed<\/b> \n
- Provide Host IP address, subnet and gateway<\/b> \n
- Provide CVM IP address, subnet and gateway<\/b> \n
- Accept licence<\/b> \n
- Start<\/b><\/ol>Installation process will take 10mins to complete<\/b>
\nAfter 10mins CVM IP address will appear on your screen, if not will get request yuor CVM is ready just ENTER to display CVM IP address.<\/b> <\/b>
\n <\/b>
\nFollow the above same steps for remaining two nodes and finish the installation.<\/b>
\n <\/b>
\nOnce finished the NutanixCE installation on 3 nodes a<\/b>ccess any server from Putty (CVM IP)<\/b>
\nUser Name: - nutanix<\/b>
\nPassword: - Nutanix\/4u<\/b>
\n <\/b>
\n
\nCreation of cluster:-<\/b>
\nConfirm all the 3 CVMs IP addresses are reachable<\/b>
\n
\n
\nType below command for create cluster:-<\/b>
\ncluster \u2013s xxx.xxx.xxx.xxx,xxx.xxx.xxx.xxx,xxx.xxx.xxx.xxx.xxx create (XXX are the CVM IP address of the 3 nodes)<\/b>
\n
\n <\/b> <\/b>
\nType the any CVM IP address or cluster management ip address in browser to access the server through PRISM<\/b>
\nUsername:-admin<\/b>
\nPassword:-admin<\/b>
\nChange ADMIN password: - XXXXXXX<\/b>
\nCreate your ID in Nutanix, if already created<\/b>
\nType the ID and password<\/b>
\nPRISM Management Console will appear.<\/b>","className":"post__content__best_answer"}"> - Unzip the image, it will unzip from .gz to .img<\/b> \n