基金会未能报酬

  • 2015年5月5日
  • 4回复
  • 1368次观点
C
徽章 +2
嗨，大家好，

我一直在试图重新描绘一块我的块，但它一直失败。

从基础日志中，它继续显示此消息。我能够使用IP地址直接访问IPMI。

停止成像线程池池池池停止截图（最近呼叫最后一个电话）：文件“/home/nutanix/foundation/lib/installer.py”，第390行，service_imaging_thread foundation_port）文件“/ home / nutanix / foundation / lib /安装程序。py“，第365行，在do_imaging imaging_step.pre_threading_prep（）文件”/home/nutanix/foundation/lib/imaging_step_type_detection.py“，第187行，在pre_threading_prep中引入standeralError（Error_Message（结果，node_config.ipmi_ip））standarderror：foundation cons'T在192.168.100.101到达IPMI接口。请仔细检查您的IP地址和网络设置。
    \n
    \nIve been trying to reimage a block of mine but it keeps failing.
    \n
    \nfrom the foundation logs , it keep showing this message. im able to access to IPMI directly using the ip address.
    \n
    \nStopping imaging thread poolImaging thread pool stoppedTraceback (most recent call last): File \"\/home\/nutanix\/foundation\/lib\/installer.py\", line 390, in service_imaging_thread foundation_port) File \"\/home\/nutanix\/foundation\/lib\/installer.py\", line 365, in do_imaging imaging_step.pre_threading_prep() File \"\/home\/nutanix\/foundation\/lib\/imaging_step_type_detection.py\", line 187, in pre_threading_prep raise StandardError(error_message(result, node_config.ipmi_ip))StandardError: Foundation couldn't reach the IPMI interface at 192.168.100.101. Please double-check your IP addresses and network setup.","quoteUsername":"chewyikai","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

    4回复

    Donniebrasco.
    秩
    UserLevel 4.
    徽章 +18
    您是否能够从Foundation VM达到IPMI IP？

    -NAV.
    \n
    \n-Nav","quoteUsername":"DonnieBrasco","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">
    C
    徽章 +2
    是的，我能够从基础本身到达IPMI的Web
    Donniebrasco.
    秩
    UserLevel 4.
    徽章 +18
    在这种情况下，我建议重新启动基础，看看它是否有效。
    尝试将Foundation VM放在同一层2网络中，以防IPMI连接，以防它不是。
    确保端口IPMI命令端口623，可访问IKVM端口5900,80和443。
    \nTry placing foundation VM in the same layer 2 network where you IPMI is connected in case it is not.
    \nMake sure port IPMI command port 623, IKVM port 5900, 80 and 443 are accessible.","quoteUsername":"DonnieBrasco","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">
    C
    徽章 +2
    我可以管理重新归类节点。

    具有IPMI固件1.87的较旧旧盒子不会与基础2.1沟通。
    升级到3.4后，我能够与基金会2.1沟通。
    \n
    \nThis slightly older box of mine with IPMI Firmware 1.87 does not communicate with Foundation 2.1.
    \nAfter upgrading to 3.4 i was able to communicate with Foundation 2.1.","quoteUsername":"chewyikai","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

    回复


    Baidu