基金会无法重塑形象

  • 2015年5月5日
  • 4回复
  • 1368的浏览量
C
徽章 ＋２
嗨,伙计们,

我一直试图重新塑造我的一个街区，但它总是失败。

从基金会日志来看，它一直显示这条消息。我可以通过ip地址直接访问IPMI。

成像线程池stoppedTraceback(最近一次调用last):File "/home/nutanix/foundation/lib/installer.py"， 390行，in service_imaging_thread foundation_port) File "/home/nutanix/foundation/lib/installer.py"， 365行，in do_imaging imaging_step.pre_threading_prep() File "/home/nutanix/foundation/lib/imaging_step_type_detection.py"， 187行，在pre_threading_prep引发标准derror (error_message(result, node_config.ipmi_ip))请仔细检查您的IP地址和网络设置。
    \n
    \nIve been trying to reimage a block of mine but it keeps failing.
    \n
    \nfrom the foundation logs , it keep showing this message. im able to access to IPMI directly using the ip address.
    \n
    \nStopping imaging thread poolImaging thread pool stoppedTraceback (most recent call last): File \"\/home\/nutanix\/foundation\/lib\/installer.py\", line 390, in service_imaging_thread foundation_port) File \"\/home\/nutanix\/foundation\/lib\/installer.py\", line 365, in do_imaging imaging_step.pre_threading_prep() File \"\/home\/nutanix\/foundation\/lib\/imaging_step_type_detection.py\", line 187, in pre_threading_prep raise StandardError(error_message(result, node_config.ipmi_ip))StandardError: Foundation couldn't reach the IPMI interface at 192.168.100.101. Please double-check your IP addresses and network setup.","quoteUsername":"chewyikai","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

    4回复

    DonnieBrasco
    排名
    Userlevel 4
    徽章 + 18
    是否可以通过基础虚拟机访问IPMI IP ?

    导航
    \n
    \n-Nav","quoteUsername":"DonnieBrasco","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">
    C
    徽章 ＋２
    是的，我可以ping并从基金会本身连接到ipmi的Web
    DonnieBrasco
    排名
    Userlevel 4
    徽章 + 18
    在这种情况下，我建议重新启动基金会，看看是否有效。
    尝试将基础VM放置在IPMI连接的同一层网络中，以防不能连接。
    请确保IPMI命令端口623、IKVM端口5900、80和443可以正常访问。
    \nTry placing foundation VM in the same layer 2 network where you IPMI is connected in case it is not.
    \nMake sure port IPMI command port 623, IKVM port 5900, 80 and 443 are accessible.","quoteUsername":"DonnieBrasco","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">
    C
    徽章 ＋２
    我设法重新映像节点。

    我的这个稍微旧一点的机器带有IPMI固件1.87，不能与Foundation 2.1通信。
    在升级到3.4之后，我能够与Foundation 2.1沟通。
    \n
    \nThis slightly older box of mine with IPMI Firmware 1.87 does not communicate with Foundation 2.1.
    \nAfter upgrading to 3.4 i was able to communicate with Foundation 2.1.","quoteUsername":"chewyikai","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

    回复


    Baidu