问题

Phoenix在minimum_reqs.py上重新映像失败

  • 2020年12月3日
  • 2回答
  • 160的浏览量
问
minimum_reqs.py

网卡已连接，但不确定其故障原因。有人知道吗?我试过用粉底4.6和4.5.4.2。网卡连接Intel和dell的固件19.5.12。现有的集群在相同的规格下运行良好。

\"//www.jhbzcj.com/next/installation-configuration-23/\"
minimum_reqs.py\u00a0<\/figcaption><\/figure>

The NICs are connected, not sure why its failing. Anyone knows? I have tried with foundation 4.6 and 4.5.4.2 . The Nics are connected an Intel with dell firmware 19.5.12. Existing cluster is running fine with same specs.\u00a0<\/p>","quoteUsername":"quacksh0t","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

2回答

科塔克奈尔
排名
Userlevel 3
徽章 ＋４

嗨 @quacksh0t

如果在我们的10gb接口中连接gbasic收发器，就会发现这些错误。这可能会导致ethtool报告10/100/1000速度不准确，导致phoenix / foundation失败，出现描述中显示的错误。

你能。请使用以下命令确认接口的速率

ethtool eth <接口>

另外，请在以下命令的帮助下确认驱动程序是否正确加载

lspci - m

Hi @quacksh0t<\/user-mention>\u00a0<\/p>

These errors are spotted if connected gbic transceivers in our 10gb interfaces. This can cause ethtool report 10\/100\/1000 speeds inaccurately, causing phoenix \/ foundation to fail with the error shown in the description.\u00a0<\/p>

\u00a0<\/p>

Could you. please confirm the speed of the interface with the help of the following command<\/p>

\u00a0<\/p>

ethtool eth<interface><\/code><\/p>

\u00a0<\/p>

Also please confirm if the drivers are loaded correctly with the help of the following command<\/p>

lspci -m<\/code><\/p>","quoteUsername":"Neel Kotak","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

问

谢谢奈尔。

我用的是粉底4.4.4，重新制作的图像实际上已经完成了!我仔细检查过了，速度是10gb。不知道为什么这个版本能工作，而最新的不能。

Thanks Neel.<\/p>

\u00a0<\/p>

I used foundation 4.4.4 and the re-image actually went through!\u00a0I have double checked, and the speed is 10gb.\u00a0\u00a0Not sure why this version worked and the latest didn\u2019t..<\/p>

\u00a0<\/p>","quoteUsername":"quacksh0t","translations":{"Common":{"like":"Like","unlike":"Unlike"},"Forum":{"Quote":"Quote","Share":"Share"}}}">

回复


Baidu